[Clfs-support] Fwd: EGlibc make check errors at 10.7

[Alonso Graterol]

---------- Forwarded message ----------
From: Alonso Graterol <alonso.graterol at gmail.com>
Date: 2009/12/28
Subject: EGlibc make check errors at 10.7
To: CLFS Support <clfs-support at lists.cross-lfs.org>


Hello,

After a smooth ride up to this point, make check throws a non expected
error as follows,

root:/sources/eglibc-build# cp -v
../eglibc-2.10.1/iconvdata/gconv-modules iconvdata
`../eglibc-2.10.1/iconvdata/gconv-modules' -> `iconvdata/gconv-modules'
root:/sources/eglibc-build# make -k check >eglibc-check-log 2>&1 ;
grep Error eglibc-check-log
ld-linux-x86-64[5940]: segfault at 315 ip 00002b67c55fc7c5 sp
00007ffff8363130 error 4 in ld.so[2b67c55ef000+1d000]
ld-linux-x86-64[7132]: segfault at 315 ip 00002af97c5097c5 sp
00007fff5db45e20 error 4 in ld.so[2af97c4fc000+1d000]
make[2]: [/sources/eglibc-build/posix/annexc.out] Error 1 (ignored)
make[2]: *** [/sources/eglibc-build/nptl/tst-cancel17.out] Error 1
make[2]: *** [/sources/eglibc-build/nptl/tst-cancelx17.out] Error 1
make[1]: *** [nptl/tests] Error 2
make: *** [check] Error 2
root:/sources/eglibc-build#

I tried twice building the package from scratch (no install yet) with
same results. This is output for 2nd try. First time there was only 1
segfault.

In both cases the last .out file mentioned in eglibc-check-log
(begin-end-check.out 1st and check-localplt.out 2nd) shows OK checks.

If I just run make check after getting the error it passes without any
warning at all. I tried that first time. I just think it's not right.

Any input is appreciated. Thanks.

Alonso




Ok, I tried a third time and it went smooth. Only the posix/annexc
Error 1 showed up as expected.

I wonder if those segfaults were due to something going wrong on the
mainboard... I hope not.

Alonso